Is there an example composition that shows mouse x/y and left click, interacting with a shader toy node, when it's in image filter format?

I am having a little trouble getting the coordinates normalized to the window as opposed to screen. I'm also not 100% sure that "Mouse Is Pressed" and "Mouse Position" are working inside of the shader toy node as iMouse.z, and iMouse.xy, respectively.

Comments

Oh, I wasn't clear I guess!

George_Toledo's picture
Submitted by

Oh, I wasn't clear I guess!

I understand how to set something like this up.

What I can't figure out is how to get the mouse coordinates normalized to the render window, WHEN the composition is setup as an image filter protocol. As far as I can tell, when it's in that format, there is no way to get info from the output window, which apparently is required in order to setup something like the QC mouse patch.

Oh sorry, I thought you meant

jstrecker's picture
Submitted by

Oh sorry, I thought you meant when the Shadertoy node was filtering an image.

There's not really a good way to use mouse interaction in an image filter composition. See "Pointer Interaction" protocol.

Unless by chance you're planning to use the image filter as a subcomposition, in which case the mouse and window nodes could be outside of the subcomposition, inputting to and outputting from it.

Darn.

George_Toledo's picture
Submitted by

Darn.

You all have done such a great job in general, but every so often, the typical useful defaults and use cases that were easily available in QC just are not here. I think maybe I coincidentally stumble on those a lot :)

There are so many different mouse related patches and if one one of them did what the one in QC did, it would eliminate the need for all of the linking together stuff. Or maybe some kind of subcomposition that could work similarly.

I will point out that a

George_Toledo's picture
Submitted by

I will point out that a fundamental part of the image filter protocol in QC is that published xy automatically receive mouse events in the editor without even hooking anything up, at least for many major versions, possibly still. That’s one better than even having to load and connect the QC mouse patch. And if you wanted to manually, you could, of course. Mouse, and other forms of hardware interaction that need to get info about the output window coordinates, are pretty fundamental to the concept of an interactive programming environment. IMO. Just making an argument for it and against the hypothesis that it doesn’t fit.

How are you getting QC image

jstrecker's picture
Submitted by

How are you getting QC image filters to take mouse coordinates automatically? In a couple of macOS versions tested here (10.13.6 and 10.8.5) they do not. The in-app documentation for the image filter indicates that X and Y are the center points of the effect.

In any case, it sounds like the behavior you would like to see — mouse coordinates fed into image filter — is the same as described in the feature request for the pointer interaction protocol. Is that correct?